Reveal Panel System

 

The Reveal Panel

The Reveal Panel system is suitable for facade cladding and can be installed both vertically and horizontally. The system consists of profiled zinc sheets with a variable width size from a 200 to 333 mm face. The Reveal Panel profiles are assembled such that a joint (reveal) is created. The Reveal Panel system is connected with a tongue and groove. The dimensions of the panels and joints are variable, as are the lengths of the reveal panels. The panel width can be used to a maximum of 300 to 333 mm. The width is reduced to 200 mm for applications in coastal areas and at high building altitudes (> 25 meters). 

Generally the system is applied with a material thickness of 1.0 mm. A standard solution is available for most connections, such as inside and outside corners. Different profiles are available, such as corner, joint  and water check profiles.

Area of application

The Reveal Panel profile forms a zinc-titanium cladding for facades. The profile offers the possibility of quickly and efficiently covering a facade with NedZink NTZ®, because prefabricated bays can be used. The pre-profiled bays are delivered on site and then fastened against the façade substructure.

Support

The facade with Reveal Panel profiles must be supported by a wooden substructure, preferably unplaned timber boarding 23 – 25 mm thick not tongue-and-grooved. The gap between the timber boards must be at least 5 to 10 mm. The boards may be spaced up to 100 mm, to be determined by the builder.

Assembly

The profiled panels are secured to the underlying timber boards, preferably using galvanized steel screws. Depending on the chosen panel profile type, a reveal is created between the different parts, that can be set between 5 and 10 mm width. The profile lengths are a maximum of 5000 mm. For lengths longer than 4000 mm, slotted holes are recommended to take up length changes of the zinc.